BENDING-MACHINE OPERATOR I JOB will do the fallowing jobs / work – 1. Sets up and operates machine to bend metal structural shapes, such as bars, rods, angles, pipes, and tubes, to angle or contour specified by work order, drawings, templates, or layout: Selects and bolts holding clamp, die block, and guide clamp to machine. 2. Positions and clamps end stops on machine to set specified location of bend. 3. Inserts or screws plug stops into guide wheel to set specified degree of bend. 4. Positions workpiece against end stop. 5. Locks holding clamp and guide clamp onto workpiece. 6. Lubricates workpiece with oil. 7. Starts turntable that draws workpiece through guide clamp around die block until stopped by plug stops or until dial indicator points to specified degree of bend. 8. May slide mandrel into tubing instead of using guide clamp. 9. May preheat workpiece, using hand torch or heating furnace. 10. May use hand-powered bending machine for short runs. 11. May fill tubes or pipe with sand, resin, or lead to prevent wrinkling or collapsing during bending operation. 12. May heat tube, using torch, and manually bend tube or pipe around forming blocks. 13. May flare tube ends, using tube flarer and cut or trim metal stock to length, using power shears or saws. 14. May be designated according to type of stock bent as Pipe-Bending-Machine Operator; Rod-Bending-Machine Operator I; Tube-Bending-Machine Operator I.
Where to apply for a job in UAE ?
Job Details: CNC MACHINE OPERATOR (Sheet Metal). Candidates should have minimum 03 years’ experience on Hydraulic sheet bending machine operator.
Job Details: Experience with bending machine experience (hydraulic press. Preferred Experience with bending machine experience (hydraulic press, plate rolling, power press…
Job Details: Operating NC bending machines would be an added advantage. Independently setup of Round section, pipe bending machines and check measurement,.
Job Details: Equipment operators typically do the following: O Coordinate machine actions with crew members using hand or audio signals. Safely perform the following duties:
Job Details: Visually inspect tools, equipment, or machines. Reach overhead and below the knees, including bending, twisting, pulling, and stooping.
Job Details: From 08:00 AM TO 12:00 PM. DIP2 Near To Al Habab Road Near Kamla Trading. Location Can Found in Google Maps ( Bin Ghurair Trading LLC ).
Job Details: Experience in Steel bending, punching and straitening Machines. Should have experience in operating CNC Machines.
Job Details: We are looking for one ‘’bending machine operators’’. Job Description will be as the designation saysb in one of our renowned clients a renowned leader in…
Jobs Data as of 2020-01-14